Call Us:  +1.302.994.8000

CECON logo

Log in

Login to your account

Username *
Password *
Remember Me


This area of the website contains blogs written by our Consultants as well as Cecon personnel

Researchers Use Opal Structure to Improve Thin Film Solar Cell Efficiency

A new approach to solar cell design is raising hopes for lower cost electricity derived from solar energy.  Researchers from Purdue University’s School of Electrical and Computer Engineering and Birck Nanotechnology Center have devised a 3-D synthetic crystal that absorbs, retains and utilizes sunlight more effectively than traditional thin-film cells

Conventional solar cells are made of single crystal silicon wafers, but those made of thin-film silicon cells are 100 times less expensive. Unfortunately, the thin-film cells’ material and structure allows sunlight to enter and then quickly reflected back out of the cell, making them much less efficient.  Purdue researchers have found that by introducing synthetic crystals with an “inverse opal structure” into the construction of the thin-film cells, that once sunlight enters the cell it is diffracted and the opal structure traps light for longer periods of time, increasing the probability of converting the solar power to electrical energy.   

According to Peter Bermel, an assistant professor participating in the study, the goal of the research was to determine whether introducing the 3-D photonic crystals into crystalline silicon solar cells would make them more efficient while maintaining their lower cost. “The question is, can we make up that lower efficiency by introducing new approaches to light trapping for thin film solar cells? Can we combine low cost and high performance?”

The study showed that the opal structure increases the thin-film cells’ efficiency and absorption of near-infrared light by approximately 10%, and that with more research greater efficiency may be gained.

Though solar cells were originally designed to be made of thick single crystal silicon wafers, the cost was prohibitive for widespread use, so the multicrystalline and thin-film silicon solar cells have gained in popularity. Unfortunately, their efficiency in absorbing near-infrared light is not optimal. According to Bermel, “Light in the near-infrared range is important because there is a lot of solar energy in that wavelength range and also because silicon can convert near infrared light to energy if it can absorb it, but thin films don’t fully absorb it.”

Continue reading
  702 Hits